foto assistance sisgeo1150 320

FAQ#075 - Which parameters are save into SISGEO digitized sensors?

All the SISGEO digitized sensors (IPIs, Tilt-meters, RDSs, H-Level etc..) use the serial RS-485 communication protocol.

The SISGEO digitized sensors are joined through an electrical cable, so only one cable is used to take reading.

In agreement with Customer, they are configured in factory for:

-    Calibration parameters

-    Serial number

-    RS-485 andress. Each digitized sensor has a univocal address also reported in a label on the cable.

-    Powering type:

o    always on (all digitized sensor switched on together)