Modbus protocol specification for SISGEO digital instruments in NORMAL MODE with FW version 3 or higher
FAQ#116 - How do I configure a WR-Log digital node to read RS485 Sisgeo TIMED sensors?
FAQ#110 - What's the purpose of the linear and polynomial factors written in the Calibration Reports?
FAQ#095 - How long does a chain of digital sensors take to be read?
FAQ#094 - Which are the available powering modes for SISGEO digital sensors?
FAQ#073 - Which is the maximum number of digitized sensors (RS-485, Modbus), the maximum number of chains and the maximum length of cable in a RS-485 network?
FAQ#077 - Which are the maximum cable lengths from instrument to datalogger?
FAQ#076 - Why it is necessary add a termination resistor to the last digitized sensor of each RS-485 chain?
FAQ#075 - Which parameters are save into SISGEO digitized sensors?